So if you want 10 layers at the bottom of your part - then with the .3 setting it will put a first layer of your bottom layer down a bit thicker to hold the part, and then complete the 7 other layers to give you 1mm [I think that it right and that the base layer would not be 1.2mm but don't know that for sure.]
Actually, no... it should give you 0.3 + [7 x 0.1], I agree, but it doesn't. The number of solid layers on the bottom doesn't take into account the first layer thickness. So you get 0.3 + [9 x 0.1] instead.
Well, actually, no, you get 0.3 + [10 x 0.1] because there's another bug that you always seem to get one more top/bottom layer than you should.
What is the best top and bottom thickness for 3D printing?
Common values for printing regular, moderately strong parts include a wall thickness of 0.8-1.6 mm [3-4 wall lines] and a top and bottom thickness around 0.8-1.2 mm [4-6 layers depending on the layer height set].nullWall Thickness [3D Printing]: How to Make It Perfect - All3DPall3dp.com › ...null
What are top surface skin layers in Cura?
Top surface skin is the top-most layer of top skin, which can be adjusted separately. This allows to print a preset number of layers at a higher quality which results in a better surface finish.8 thg 11, 2022nullTop and Bottom settings - MakerBot Supportsupport.makerbot.com › articlenull
What are bottom shell layers?
Bottom layers [a type of shell]: The part of the print that is exposed to the outside of the model, facing the build plate. Top layers [a type of shell]: The parts of the print that is exposed to the outside of the model, facing upwards, towards the nozzle.nullWhat are the optimal shell and infill parameters for FDM 3D printing?www.hubs.com › knowledge-basenull
What should the bottom layer of a 3D print look like?
Underneath, its bottom surface has a clean and uniform pattern. If you were to print a cube with this setting, you wouldn't see any flare out or tapered in at the base from the Z-offset being too far or too close, respectively. A calibration 3D print with the Z-Offset set perfectly.null3D Printing 101: How to Succeed with a Perfect First Layer for Every 3D Printwww.matterhackers.com › articles › 3d-printing-essentials-first-layernull